Hot working, mainly including forging, rolling and extrusion, is the basic production method of titanium flange semi-finished products and products. In view of the strong sensitivity of titanium flange structure to hot working process, the correct selection and mastery of process parameters are not only very important to ensure the dimensional accuracy of products, but also a key factor for the internal quality of products.
Compared with general metal structure materials, titanium flange hot working is characterized by large deformation resistance and narrow deformation temperature range. Titanium with hexagonal crystal structure is not easily deformed. To improve plasticity, it is necessary to heat the metal to the b phase zone above the phase transition point and perform so-called b processing. However, due to the high overheating tendency of titanium flange, high temperature heating will cause rapid growth of b grain. However, if the deformation is insufficient, the formation of coarse Widmanstatten structure after cooling will significantly reduce the periodicity and fatigue strength of the alloy. However, this overheating structure is difficult to eliminate in the subsequent heat treatment. Therefore, the critical point Tb is not required for the starting temperature of hot working of the finished product or the previous heat of the finished product in the current production. Due to the sensitivity of the deformation resistance of titanium flanges to a decrease in deformation temperature or an increase in deformation rate, the stopping forging temperature cannot be too low. The constraints of these two factors limit the processing temperature range of most titanium flanges to between 800 and 950 ℃, making it difficult to master. However, for the opening of ingots, the temperature range can be extended to 850-1150 ℃, and the temperature can be gradually reduced during subsequent processing.
Titanium flange alloy has poor thermal conductivity. During rapid deformation, the temperature rise in the center of the workpiece is fast, which can easily cause overheating due to slow heat transfer. However, the surface temperature of the workpiece is relatively low, and surface cracks are easily formed. Therefore, it is necessary to pay attention to the deformation rate and amount during the processing.
Country:China
Add:Baoti road,Jintai,Baoji city,Shaanxi,China
Cel/Whatsapp :+86 18309262795
Email:annie@jmyunti.com
Website:www.jm-titanium.com









